User Guide

Single Light Installation

Graphic Tutorial


01 SINGLE LIGHT COMPONENTS

PRODUCT INTRODUCTION

Use individually or combine multiple units for custom installations
Metal Stakes X 1,Light Fixture X 1,Remote X 1

NOTE

Single light is equiped Aurio’s Low Voltage Quick Connectors

02 INSTALLATION STEPS

STEP 01 INSTALL SPIKE

Attach Metal Stakes to Light Fixtures

STEP 02 PREPARE THE CABLE

For optimum results, please use either 12/2, 14/2 or 16/2 AWG wire

depending on the distance and total wattage required for your application

Carefully separate the two Low Voltage wires using a sharp knife

without damaging the insulation of the power cable

STEP 03 CONNECT THE CABLE

Unscrew the protective cap from Aurio’s Low Voltage Quick Connector

Place the separated wires into the protective caps

and reattach Aurio Low Voltage Quick Connector

Thread the cap tightly to ensure the point pierces the insulation and makes contact with the wire

NOTE

Wire polarity is not required for this product

STEP 04 INSTALLATION

Press the stake firmly into the ground

Do not use a hammer or use excessive force on the fixture itself during installation